Setup Of Evr Tool; Function (Ver.3.2) - Panasonic AJ-D400P Service Manual

Setup of EVR Tool

1. Turn the power switches of the camera recorder
and the EVR off. Connect the tools as shown in
figure.
VFK1180
EVR
I/F BOX
VFKW1000AA
DC
6V
2. Turn the power of PC and EVR ON and then
camera recorder ON.
3. Pressing [SHIFT],[+] and [-] buttons in operation
panel, set the MENU SW to SET.
4. Press the PAGE button to open the SERVICE
ADJ. menu. Select EVR in ECU CONNECT. After
setting turn the MENU OFF.
5. Execute the CAM_TOOL.EXE on command
prompt condition to start EVR program.
6. Follow the displayed instructions until MAIN
MENU is shown. (If the bar graph stops before
100% and MAIN MENU is not opened, turn the
power of I/F box (VFKW1000AA) OFF and ON.
Then execute the EVR program again.)
SIGNAL
GENERATOR
VECTOR
SCOPE
GEN LOCK EXT SYNC
WFM
VIDEO OUT
CAM OUT
ECU
VFK1187
Serial (COM)
Port
VFKW1000C

Function (Ver.3.2)

MAIN MENU
1. BACK UP (DOWN LOAD) RAM DATA.
2. RESTORE (UPLOAD) RAM DATA.
3. PREPARATION OF ADJUSTMENT.
4. START ADJUSTMENT.
5. ELECTRICAL ADJUSTMENT.
6. E.V.R. DIRECT FUNCTIONS.
7. BACK UP (DOWN LOAD) RAM DATA.< OPTION >
8. RESTORE (UPLOAD) RAM DATA
9. CREATE ADJUSTMENT ITEM <PRODUCTION>
10. START ADJUSTMENT
1, 2 : NV-RAM DATA is backed up and restored.
Back up data is named as --------. SAV.
".SAV" is automatically added. MENU data
and adjustment data can be backed up.
3 ~ 5 : Not supported.
6 : Refer to next page.
7,8 : Blemish correction data can be backed up
and restored The address is as follows.
5E60h-5E7Fh
9. : Not supported.
10. : Refer to next page.
< OPTION >
<PRODUCTION>