A/C Head Tilt Adjustment - Panasonic AJ-D400P Service Manual

Dvcpro series camera recorder

Hide thumbs Also See for AJ-D400P:

Table of Contents

1-16. A/C Head Tilt Adjustment

Lower limit at T3 Post

No tape curl

ADJUSTMENT SCREW A and G (A/C Head)

VFK1148, VFK1178 (Hex Driver)

1. Play back the tape and adjust screw(A) for

adjustment of tilt of A/C Head so that the tape

path has lower limit without curl at T3 post.

2. To adjustment, loosen the screw (G) and

make curl on tape at lower flange of T3 post

by screw (A). And

accordingly for

disappeared. After finish adjustment for screw

(A), tighten the screw (G) is tightened with

1.0Kg/cm of torque.

1. In case of turn clockwise screw (A).

→ Tape goes up at T3 post.

2. In case of turn counter-clockwise screw (A).

→ Tape goes down at T3 post.

3. When screw adjustment finished, with each

adjustment screw on A/C Head should be

finished tighten direction. And confirm that the

screw does not loosen.

4. Adjust and confirmation should be performed

alternately with each A/C head adjustment

(Azimuth and Height).

tighten screw (A)

Table of Contents