Tension Arm Unit Replacement - Panasonic AJ-D400P Service Manual

10-15. Tension Arm Unit
Replacement
(Removal)
1. Remove the Cassette Cover and Left Side Panel.
2. Remove the Cassette Up Unit.
3. Remove the Cut Washer (A) and pick up the
Tension Regi Spring Then remove the Tension
Arm Unit as shown in Figure 10-15-1.
(Installation)
1. Install the new Tension Arm Unit according to the
opposite procedures to removing.
2. After installing, Tension Arm Adjustment should
be performed as follows.
Fig. 10-15-1 Removal of Tension Arm Unit
Tension Arm Adjustment Flowchart
START
1-6. TENSION OFFSET ADJUSTMENT
1-7. NEUTRAL POSITION ADJUSTMENT
1-8. PLAYBACK VOLTAGE ADJUSTMENT
1-8. REV VOLTAGE CONFIRMATION
1-9. TENSION SPRING ADJUSTMENT
1-10. REV TENSION CONFIRMATION
END
OK
NG
NG