Burst Phase Adjustment (For Pal Only); Quad Adjustment (For Pal Only); Burst Level Adjustment (For Pal Only); Croma Level Adjustment (For Pal Only) - Panasonic AJ-D400P Service Manual

6-15. Burst Phase Adjustment
(for PAL only)
BOARD Video I/F
VIDEO OUT (75 W terminated)
TEST
ADJUST VR608
MODE PLAY
TAPE VFM3680KM (0 ~ 10min)
M.EQ Vector Scope
1. Adjust the VR608 so that the burst vectors are
fixed on the scale.

6-16. QUAD Adjustment (for PAL only)

BOARD VIDEO I/F
VIDEO OUT (75 W terminated)
TEST
SPEC. A = B
ADJUST VC601
MODE PLAY
TAPE VFM3680KM (0 ~ 10min)
M.EQ
Vector Scope
1. Adjust the VC601 so that the burst level A and B
are the same.
6-17. Burst Level Adjustment
(for PAL only)
BOARD Video I/F
SPEC.
100%
VIDEO OUT (75 W terminated)
TEST
ADJUST VR607
MODE PLAY
TAPE VFM3680KM (0 ~ 10min)
M.EQ Vector Scope
1. Adjust the VR607 so that the burst levels are
within specification.
6-18. Chroma Level Adjustment
(for PAL only)
BOARD Video I/F
VIDEO OUT (75 W terminated)
TEST
ADJUST VR604, EVR
MODE PLAY
TAPE VFM3680KM (0 ~ 10min)
M.EQ Vector Scope
Menu Setting
1. Open the operation panel.
2. Pressing [SHIFT], [+] and [-] buttons, set MENU
switch to SET position.
3. Set as follows:
PAGE : FUNCTION 3/5
ECU CONNECT
PAGE : SERVICE ADJ.
IF ADJ.
EVR Setting
CMD : 02 DATA : 86
1. Press [®] or [¬] key in EVR so that the R dot is in
the marker of the vector scope.
2. If necessary, fine-adjust the VC601.
3. Adjust the VR604 so that each dot is in the marker
of the vector scope.
: EVR
: OFF
ADR : 16