Main Cam Gear Replacement; T4 Post Phase Adjustment - Panasonic AJ-D400P Service Manual

10-16. Main Cam Gear Replacement

(Removal)
1. Remove the Cassette Cover and Left Side Panel.
2. Remove the Cassette Up Unit.
3. Remove the Pinch Solenoid Unit (Refer to item
10-5) and Loading Motor Neutral Unit (Refer to
item 10-4).
4. Remove the Main Cam Gear as shown in Figure
10-16-1.
(Installation)
1. Install the Main Cam Gear so that the pin of Main
Cam Arm Unit (*) matches the groove position of
Main Cam Gear as shown in Figure 10-16-1.
2. Follow the opposite procedures to removing.
3. After installing,
Adjustment is required (Refer to item 1-2 of
section 3).
Fig. 10-16-1 Removal of Main Cam Gear
Pinch Solenoid Position

10-17. T4 Post Phase Adjustment

1. Confirm that the hole (B) of T4 Connector Gear
was matched to hole of T4 Post as shown in figure
10-17-1.
2. Confirm the relation between portion (C) of T4
Connector Gear and hole (A).as shown in
Figure 10-17-1.
Note: This confirmation should be performed on
unloading condition.
1. If not, adjust the phase of T4 post follow the above
procedure.
Fig. 10-17-1 Phase of T4 Post