Panasonic AJ-D400P Service Manual page 31

(Installation)
1. Install the new Cylinder Unit according to the
opposite procedures to removing.
2. After installing T1 Guide, T1 Guide position
adjustment should be performed (Refer to item
10-8-1).
Note: When installing the Cylinder Unit, the pin on
Mech. Chassis should match hole of Cylinder
Unit as shown in Figure 10-1-3.
Note: Please put the flexible (B) and (C) between
copper shield plate (D) and (E) as shown in
Figure 10-1-5.
Fig. 10-1-5
Fig. 10-1-3