Camera Input Vector Adjustment; Video Input Vector Adjustment (For Ntsc Only) - Panasonic AJ-D400P Service Manual

6-25. Camera Input Vector Adjustment

BOARD Video I/F
VIDEO OUT (75 W terminated)
TEST
ADJUST VR108 (PB LEV), VR112 (PR LEV), EVR
INPUT CAMERA Color Bar
MODE EE
M.EQ Vector Scope
Menu Setting
1. Open the operation panel.
2. Pressing [SHIFT], [+] and [-] buttons, set MENU
switch to SET position.
3. Set as follows:
PAGE : FUNCTION 3/5
REC SIGNAL
ECU CONNECT
PAGE : SERVICE ADJ.
IF ADJ.
PAGE : LEVEL 3/6
SET UP
only)
EVR Setting
CMD : 02 DATA : 63
CMD : 02 DATA : 63
1. Adjust the VR108 and VR112 and press [®] or [¬]
key in EVR so that the vector center is at the center
of the vector scope and each dot is in the marker of
the vector scope.
<Note>
Do not use the extension board when execute this
adjustment.
: CAM (NTSC only)
: EVR
: ON
: 7.5% (NTSC
ADR : 12
ADR : 13
6-26. Video Input Vector Adjustment
(NTSC only)
BOARD Video I/F
VIDEO OUT (75 W terminated)
TEST
ADJUST VR105 (PB LEV), VR109 (PR LEV), EVR
INPUT CAMERA Color Bar
MODE EE
M.EQ Vector Scope
Menu Setting
1. Open the operation panel.
2. Pressing [SHIFT], [+] and [-] buttons, set MENU
switch to SET position.
3. Set as follows:
PAGE : FUNCTION 3/5
REC SIGNAL
ECU CONNECT
PAGE : SERVICE ADJ.
IF ADJ.
EVR Setting
CMD : 02 DATA : D0 ADR : 19
1. Adjust the VR105 and VR109 and press [®] or [¬]
key in EVR so that each dot is in the marker of the
vector scope.
<Note>
This adjustment execute after completed the following
item "6-19. Camera Input Vector Adjustment".
: VIDEO
: EVR
: ON