Loading Motor Unit Replacement; Pinch Arm Unit Replacement - Panasonic AJ-D400P Service Manual

10-4. Loading Motor Unit
Replacement
(Removal)
1. Remove the Cassette Cover and Left Side Panel..
2. Remove the Cassette Up Unit.
3. Disconnect the connector P612 on Servo
P.C.Board as shown in Figure 10-3-1.
4. Remove the Pinch Solenoid Unit (Refer to item
10-9).
5. Remove the Pinch Solenoid Lever. (Refer to item
10-5).
6. Unscrew the screw (B) to remove the Emergency
Shaft as shown in Figure 10-4-1.
7. Unscrew the 2 screws (C) to remove the Loading
Motor Neutral Unit as shown in Figure 10-4-1.
Unscrew the 2 screws (D) to remove the Loading
8.
Motor Unit as shown in Figure 10-4-1.
Fig. 10-4-1 Removal of Loading Motor Unit
(Installation)
1. Install the new Loading Motor Unit to Loading
Motor Neutral Unit and tighten 2 screws (D).
2. Install the Loading Motor Neutral Unit and tighten
the 2 screws (C) so that the pin of Mode SW Unit
matches groove position of main Cam Gear.
3. Install the Emergency Shaft and tighten the screw
(B).
4. Install the Pinch Solenoid Unit. After installing,
Pinch Solenoid Position adjustment is required.
(Refer to item 1-2 of Section 3).

10-5. Pinch Arm Unit Replacement

(Removal)
1. Remove the Cassette Cover and Left Side Panel.
2. Remove the Cassette Up Unit.
3. Disconnect the connector P610 on the Servo
P.C.Board as shown in Figure 10-3-1.
4. Remove the Pinch Solenoid Unit (Refer to item
10-9, and pull up the Pinch Solenoid Lever as
shown in Figure 10-5-1.
5. Remove the cut washer (A) to remove the Pinch
Solenoid Lever as shown in Figure 10-5-1.
6. Remove the cut washer (B) to remove the Pinch
Arm Unit as shown in Figure 10-5-1.
(Installation)
1. Install the new Pinch Arm Unit according to the
opposite procedures to removing. Pinch Solenoid
Position Adjustment is required. (Refer to item 1-2
of Section 3.)
Fig. 10-5-1 Removal of Pinch Arm Unit