Connection Devices (Rj45 Connector And Distributor) - Mitsubishi MELSEC iQ-F FX5 User Manual

• When using a wire ferrule with insulation sleeve
Because it is difficult to insert a cable into an insulating sleeve depending on the thickness of the cable sheath, select the
proper cable according to the outline drawing.
FX5U CPU module built-in RS-485 port
Contact area
Insulating sleeve
(crimp area)
6 mm
2 to 2.5 mm
10.5 to 12 mm
<Reference>
FX5U CPU module built-in RS-485 port
FX5UC CPU module built-in RS-485 port
FX5-485-BD
FX5-485ADP
• Tool
For tightening the terminal, use a commercially available small screwdriver with straight tip that is not widened
toward the end as shown below.
■Precautions
If the diameter of the screwdriver tip is too small, the required tightening torque cannot be achieved. To achieve
the appropriate tightening torque shown in the previous page, use the following screwdriver or its equivalent
(grip diameter: approximately 25 mm).
<Reference>
Manufacturer
PHOENIX CONTACT GmbH & Co. KG

Connection devices (RJ45 connector and distributor)

Prepare the following devices if necessary.
Product name
RJ45 connector
Distributor
FX5UC CPU module built-in RS-485 port, FX5-485-BD, FX5-
485ADP
Insulating sleeve
2.6 mm
Manufacturer
PHOENIX CONTACT GmbH &
Co. KG
Model name
SZS 0.42.5
Model name
5-554720-3
BMJ-8
BMJ-8-28N (no internal connection for pins 2 and 8)
(Do not use plug with termination resistor.)
Contact area
(crimp area)
8 mm
14 mm
Model name
AI 0.5-6WH
AI 0.5-8WH
0.4 mm
Manufacturer
Tyco Electronics Japan, Ltd.
HACHIKO ELECTRIC CO., LTD
5 INVERTER COMMUNICATION
Crimping tool
CRIMPFOX 6
CRIMPFOX 6T-F
With straight tip
2.5 mm
105
5.5 Wiring
5