Konica Minolta BIZHUB PRESS C1100 Daily Maintenance Manual page 79

21
Change the measurement number on the
right side of [Select] and check the [ E
Ave], [ E Max] values, and the [ a] [ b]
graph of the Gray displayed within the
[Gray Step] frame.
As for the Gray, check the information
within the [Gray Step] frame and select
the calibration data that has the smallest
difference from the target. Then click
[Register the selected result.] .
Tips
- When you put a priority on the gray reproducibility of
the low density, check the left half of the [ a] [ b]
graph that is displayed within the [Gray Step] frame.
And select the calibration data that [ a] and [ b]
values are close to "0".
- When you put a priority on the gray reproducibility of
the high density, check the right half of the [ a] [ b]
graph that is displayed within the [Gray Step] frame.
And select the calibration data that [ a] and [ b]
values are close to "0".
22
Click [OK] on the [Information] screen.
The calibration table is registered in the image
controller.
bizhub PRESS C1100/C1085
3-38
3