Maximum Density Auto Adjustment (Ru) - Konica Minolta BIZHUB PRESS C1100 Daily Maintenance Manual

)Maximum Density Auto Adjustment (RU)

NOTICE
To enable this function, your service representative must specify the target maximum density value (target density) in
advance. For more information, contact your service representative.
Before you carry out Maximum Density Auto Adjustment (RU), check that the configuration of Screen 1 is Dot190. If
Screen 1 is not configured to Dot190, perform "Change setting of Custom Screen"
to Dot190.
Carry out Maximum Density Auto Adjustment (RU) using the paper that is used to register the target maximum density
value (target density).
1
Press [Adjustment] on the [MACHINE]
screen.
2
Press [Max.Density Auto Adj. (RU)].
3
Press [Print Mode].
4
Load the paper that has been used to register the target density into the tray.
The paper profile of the tray is automatically switched to the paper profile that has been used to register
the target density.
3-61
(Page 3-47), and change Screen 1