Konica Minolta BIZHUB PRESS C1100 Daily Maintenance Manual page 26

9
Press [a] to [d] of each point, and enter
the adjustment value using the keypad,
[,], or [+] on the screen.
10
When entry processing is completed,
press [Adjustment Start].
The input adjustment value is reflected to the
"Zoom" value and the "Image Shift" value at the
[Back] screen.
When [User Setting] - [Common Setting] - [Back
Side Magnification Adjustment] - is configured to
[OFF], the adjustment value is not reflected to
[Horizontal] at the [Back] screen.
11
Press Start on the control panel.
A test chart is printed out.
NOTICE
Output about 3 charts.
12
Check the gap of the printing position referring to the charts that are output as the
second and third sheet.
Repeat steps 10 to 13 until all gaps between the front and back sides are cleared.
2-14