13
When the following message is displayed, place the instrument flat on the calibration
dock and click [OK].
For FD-5BT, click [OK] while you press down the FD-5BT.
14
Stack 10 sheets of blank paper whose type is the same as that of the paper where
chart has been printed, and place the printed chart on top of it.
15
When the following message is
displayed, click [OK].
16
Carry out the measurement in sequence from row A.
-
Hold down the side button of i1Pro/i1Pro2 or FD-5BT. When "bleep" sounds, slide i1Pro/i1Pro2 or
FD-5BT while holding down the side button.
Slide the spectrophotometer to the opposite side, then release the side button.
-
For details about how to use i1Pro/i1Pro2 or FD-5BT, refer to the manual supplied with the
spectrophotometer.
Tips
For FD-5BT, use the FD-5BT after you release the lock lever of the target mask and remove the target mask.
bizhub PRESS C1100/C1085
3-36
3