How To Go To A Position Selected On Screen - Furuno TZT9 Operator's Manual

4.11.2

How to go to a position selected on screen

You can set a position as a point to go to without saving the point. The point is erased
when the navigation is cancelled or the power is turned off.
1. Select the position to set as a point to go to. The pop-up menu appears.
2. Select [Go To].
Arrival area (Appears when
you select [Circle and
Cross Line] or [Circle] in
the [Routes] - [Waypoint
Switching Mode] menu.)
Boat icon (current position)
The following occurs:
• The go to point is highlighted.
• A thick red dashed line and a yellow line appear. The thick red dashed line is the
course to follow to get to the point. The yellow line is the shortest course from the
current position to the go to point.
• The go to point is numbered "1" and the position where the [Go To] function starts
is numbered "0".
• The arrival area marker appears if activated on the menu (see paragraph 5.9.5).
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines with [Display XTE Lines] on [Routes] of the main menu.
Note: If you want to be notified when you reach the go to point (the end of a route),
turn on [End of Route Notification] on [Routes] of the main menu (see
paragraph 5.9.9). Then the message "End of Route" appears when you reach the end
of a route. For the arrival timing, see paragraph 5.9.5.
XTE (Cross-track Error)
XTE lines (Red: port, Green: starboard)
1 1
Go to point
Thick red dashed line:
Course between the go to
point and the point where
the [Go To] function starts.
Yellow line: Shortest
course from the current
position to the go to point.
0 0
4. POINTS
4-13