Furuno TZT9 Operator's Manual page 272

1
Fish Finder Alarms
Fish Alarm
Fish Alarm Level (Low, Medium, High)
Initial Setup
Transducer Draft (0~99.9; 0)
Salt Water (OFF, ON)
Transducer Setup (Show the menu for setting up the transducer)
Transmission Power Auto (OFF, ON)
Transmission Power (0~10; 10)
External KP (OFF, ON)
Bottom Level (-40~40; 0)
Auto Gain Offset (Multi-Sounder) (-5~5; 0)
Auto Gain Offset (Side Scan) (-5~5; 0)
Auto Gain Offset (Cross Section) (-5~5; 0)
STC (Side Scan) (0~10; 5)
STC (Multi-Sounder) (0~10; 5)
TX Pulse (Short1, Short2, Std, Long)
DFF-3D Monitoring
Set Hardware to Factory Default
Reset Default Settings
Alarm Hardware Alarm (ON, OFF)
XTE Alarm (ON, OFF)
Depth Alarm (ON, OFF)
Depth Alarm Value (30 ft)
Sea Surface Temperature Alarm (Off, Over, Under, Within, Out of)
Temperature Alarm Value (70.00
Temperature Alarm Range Minimum Value (60.00
Temperature Alarm Range Maximum Value (70.00
Speed Alarm (Off, Under, Over)
Speed Alarm Value (10.0 kn)
Speed Alarm Output (ON, OFF)
Anchor Watch Alarm (ON, OFF)
Anchor Watch Alarm Value (50 yd)
Notification Sound (Off, Sound 1, Sound 2, Sound 3)
Alarm Sound (Off, Sound 1, Sound 2, Sound 3)
Sound Alarm Until Acknowledged (ON, OFF)
External Volume (0 - 100; 50)
Reset Default Settings
1
(OFF, ON) Range Minimum Value
Range Maximum Value
°
F)
APPENDIX 1 MENU TREE
(0~1200; 0m)
(0~1200; 3m)
°
F)
°
F)
AP-7