How To Start Navigation From A Route Point - Furuno TZT9 Operator's Manual

5. ROUTES
to get to the 1st route point. The yellow line is the shortest course from the current
position to the go to point.
• The go to point is numbered as "1".
• The arrival area marker appears if activated on the menu (see paragraph 5.9.5).
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines with [Display XTE Lines] on [Routes] of the main menu.
Note: If you want to be notified when you reach a go to point, turn on [Waypoint Cross-
ing Notification] on [Routes] of the main menu (see paragraph 5.9.8). Then the mes-
sage "Waypoint Crossing" appears when you reach a go to point. For the arrival
timing, see paragraph 5.9.5.
5.8.3

How to start navigation from a route point

1. Select the route point of the route from where to start navigation. The pop-up
menu appears.
2. Select [Activate From].
In the above example, the following occurs:
• The route point "3" is selected to start navigation from, and is highlighted.
• The current position is numbered "2" and the numbers of the previous route points
decrease one by one.
• The line from "3" to the route point "5" for the selected route turns red and the legs
for "0" and "1" turn gray.
• A thick red dashed line and a yellow line run between the current position "2" and
the "3" route point. The thick red dashed line is the course to follow to get to the
route point "3". The yellow line is the shortest course from the current position to the
route point "3".
• The arrival area marker appears if activated on the menu (see paragraph 5.9.5).
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines with [Display XTE Lines] on [Routes] of the main menu.
Note: If you want to be notified when you reach a go to point, turn on [Waypoint Cross-
ing Notification] on [Routes] of the main menu (see paragraph 5.9.8). Then the mes-
sage "Waypoint Crossing" appears when you reach a go to point. For the arrival
timing, see paragraph 5.9.5.
5-10