Furuno TZT9 Operator's Manual page 75

2. CHART PLOTTER
To use the trackback feature, select the active track to display the pop-up menu. Se-
lect [Track Back] to start operation as shown below.
• A yellow line runs between your ship and the destination (the shortest course).
• A thick red dashed line runs between first destination and point where the track back
starts.
• Route points are automatically created.
• Arrows on the track point in the direction to follow the route.
• The XTE lines appear when you turn on these lines.
Track
When you are following a route, you can do the following from the pop-up menu. Se-
lect the yellow line to display the pop-up menu.
• [Stop Nav.]: Stop following the route.
• [Restart Nav.]: Restart following the route.
• [Skip Wpt]: Skip a waypoint.
• [Rte Detail]: Open the [Route Detail] list.
• [Edit]: Open the [Editing Route] window.
• [Lists]: Open the lists.
• [Extend]: Extend a route from the last point on the route.
For additional information, see the chapter 5.
2-20
Activate
[Track Back]
XTE lines
First go
to point
Route
point
Yellow line: Shortest
course from the current
position to the go to point
Point where the
track back starts
0
Thick red dashed line:
Course between first go to
point and the point where
1
the [Track Back] function
starts
Arrows point in
2
direction to follow route
3