Furuno TZT9 Operator's Manual page 20

Operation with two fingers
Rotate
Put one finger on the
boat icon then rotate
the other finger.
For TZT9/TZT14, when both RotoKey
function, this manual states the operation by touch control.
Notes for touch control
• A large amount of waterdrops on the screen can cause misoperation and slow touch
response. Wipe the screen with a dry cloth to remove the water.
• This equipment uses a capacitive touch screen. Tap the screen with your fingertips
directly. Do not use sharp objects (needle, pen, nail) or a stylus pen. Be careful not
to scratch the screen.
• Do not tap the screen with gloved fingers. Misoperation or no response can result.
• Do not put objects (stickies, etc.) on the screen. The touch control can fail to work
properly.
• Keep the equipment away from a radio antenna, fluorescent light, solenoid valve or
other electronic devices to prevent false operation from noise.
• The front panel is made of glass. If the front panel is damaged, do not try to repair
it yourself. Unauthorized repair will void the warranty. Contact your dealer about re-
pair or replacement.
• For TZTBB, see the manuals for the touch monitor.
How to lock the touch screen
The touch screen can be locked to prevent operation.
With the power applied, press the
Set the flipswitch for [Lock Touch Screen] to the [ON] position to lock the touch screen,
or the [OFF] position to unlock the touch screen.
Note: The [Lock Touch Screen] flipswitch is displayed only on TZT9/TZT14.
Boat icon
TM
and touch control are available for the same
key to show the power and brilliance window.
1. SYSTEM INTRODUCTION
Function
Switch between head up
and north up in the 2D/3D
modes.
1-5