How To Create Routes With Selected Tracks - Furuno GP-3700 Operator's Manual

6. ROUTES
2) Press the WPT key where you want to register the current own ship position
as the waypoint. The message "ADDED WAYPOINT xxxxxx TO ROUTE
XXXXXX." appears.
3) Press the WPT key where you want to change the course. The message same
with the one in step 2 appears.
How to stop creating track-based routes
Follow the procedure below to stop creating a track-based route. Creation is automat-
ically stopped when 100 waypoints have been entered, with the message "REACHED
MAX. NO. OF WPTS REGISTERED IN A RTE." shown on the screen. Push the EN-
TER knob.
1. Press the MENU key to open the main menu.
2. Select [1. ROUTES/WAYPOINTS LIST].
3. Select [2. ROUTES LIST].
4. Select [BACK TRACK].
5. Select [NO].
6. Press the DISP key to close the menu.
6.1.3

How to create routes with selected tracks

You can create routes with the selected tracks of own ship or other ships.
1. Press the MENU key to open the main menu.
2. Select [5. MARK/TRACK EDIT/DELETE].
3. Select [7. TRACK ROUTE CONVERSION] to show the [TRACK ROUTE CON-
VERSION] window. Memory points for tracks are displayed with little squares.
4. Select start memory point (
5. Select ending memory point (
6. Select [DISTANCE] in [FILTER SET].
7. Press the numeric keys to set the distance in order to filter the memory points for
the route. Memory points that meet both of the following conditions are registered
as waypoints for the route.
• The distance between two track memory points is farther than the distance set
here.
• The angle between two track memory points is larger than the angle set at
step 9.
8. Select [ANGLE] in [FILTER SET].
6-4
) to convert the route.
) to convert the route.