Furuno TZT9 Operator's Manual page 15

SYSTEM CONFIGURATION
TZTBB
DRS4D-NXT
Radome Radar
Sensors
DRS4DL
SUPPLY
PSU-017
12-24 VDC
Multi Beam Sonar DFF-3D
12-24 VDC
FI-50, etc.
IF-NMEA2K1/2
MCU-002/004
CCD Camera
CCD Camera
Environmental category
Sensor units: Exposed to the weather
All other units: Protected from the weather
* 1 : A power supply is required for the following antenna units:
DRS2D/4D/4A/6A/12A: PSU-012
DRS25A: PSU-013
DRS2D/4D: PSU-017
: FUSION MS-700 series only.
* 2
* 3 : Hatteland Display monitor.
Note 1: Do not connect or disconnect the DVI cable between TZTBB and the touch monitor while
TZTBB is powered.
Note 2: When connecting two monitors, resolutions and aspect should match between two mon-
itors. Both screens show same images (compatible with clone mode only).
xiv
Select one of radome
or open array sensor.
DRS2D/DRS4D
POWER
UNIT*
12-24 VDC
NAVpilot-700
SC-30
GP-330
FI-5002
12/24 VDC
DRS6A X-Class/DRS12A X-Class/
DRS25A X-Class
Open Array
Radar Sensors
DRS4A/DRS6A/DRS12A/DRS25A
POWER SUPPLY
PSU-012/PSU-013
12-24
VDC
FCV-1150, BBDS1, DFF series
FAR-2xx7 series
FA-30/50
HUB -101
FAX-30
IP Camera
FUSION-Link equipment
Processor Unit
MPU-002
Event SW
External Buzzer
Speed Alarm
Switch Box
Power input for CAN bus
PSD-002
* 2
UNIT* 1
24 VDC
* 2
Network equipment
Touch Monitor
* 3
HD19T21-MMD-MA1-FHGP
or
HD24T21-MMD-MA1-FHGP