Furuno TZT9 Operator's Manual page 254

3. Select [+] for [Add a new screen].
Display
division
4. Drag the desired display division (full-screen, two-way or three-way) to the custom
display area.
5. Drag the desired display from the possible displays to the custom display area.
6. Select [Save] to save the setting. Your arrangement of displays appears on the
screen and the display selection window is updated according to your arrange-
ment.
How to delete a screen
A maximum of 10 to 12 screens can be used. If you need to add another screen, delete
an unnecessary screen to make space.
1. Press the Home key (or tap the Home icon) to show the display selection window.
2. Select [Edit] at the top right-hand corner of the screen.
3. Select [] in the screen to delete.
4. Select [Close].
Note: When a sounder or plotter sensor is installed, the default screens are automat-
ically set according to the sensor. The default screens cannot be deleted. The number
of screens which you can add, edit or delete decreases according to the number of the
default screens. For example, when a sounder, radar and plotter sensors are installed,
the two-way split screen for sounder/plotter and the full screens for plotter and radar
are set as the default screens. These three screens cannot be edited or deleted. In
this case, a maximum of seven screens can be added, edited or deleted.
14. HOW TO ADJUST SETTINGS
Custom display area
Possible displays
14-9