Furuno TZT9 Operator's Manual page 23

1. SYSTEM INTRODUCTION
Remote Control Unit MCU-004 group setting
If multiple NavNet TZtouch2 units are installed in the network, you can the select the
display to show on a unit, using the MCU-004. Additionally, you can select the order
in which to cycle through the displays.
Note: Confirm that there are no duplicate unit nicknames in the network. If a duplicate
name is found, change the name on the Sensor List ([Initial Setup][Sensor List]).
1. Open the main menu.
2. Open [Initial Setup]-[Remote Controller Configuration].
No.
1 The nickname assigned to the MCU-004.
2 The nickname assigned to this unit.
3 Setting for the unit connected to TZT9FB_LEFT, controlled by MCU1.
4 Set the cycling order of units controlled by MCU1. To skip a unit, select it to [Off].
5 Setting for the unit connected to TZT14MB_LEFT, controlled by MCU2.
6 Set the cycling order of units controlled by MCU2. To skip a unit, select it to [Off].
1-8
Description