1. SYSTEM INTRODUCTION
1. Select [Create local network] in [Wireless Mode].
2. Select [SSID] to open the software keyboard.
3. Enter the SSID then select [Confirm].
4. Select [Authentification].
5. Select the security from [Open], [WEP] or [WPA2 - PSK]. For [Open], go to step
8. For others, go to the next step.
Note: Select the security according to the equipment connected to the network.
Select [WEP] to connect an iPhone or iPad to the network. ([WPA2-PSK] is not
available for iOS.)
6. Select [Password] to open the software keyboard.
7. Enter the password then select [Confirm].
Note: If you entered the invalid password, the following error message appears.
1-36
Wireless LAN Settings
Wireless
Wireless Mode
Create local Wireless network
Authentification
Create local network
NAVNETTZT
Open
Open
WEP
WPA2 - PSK