Sas Connector Protector; Removing The Sas Connector Protector - Dell PowerEdge C6320p Owner's Manual

NOTE: If installed, remove the processor dust cover.
b. Mezzanine card
c. Expansion card riser assembly
d. 1.8 inch SSD carrier
e. 1.8 inch SSD
f. Memory modules
g. Air shroud
4. Follow the procedure listed in the After working inside your system section.
5. Import your new or existing iDRAC Enterprise license. For more information, see Integrated Dell Remote Access Controller
User's Guide, at Dell.com/esmmanuals.
6. Ensure that you:
a. Enter the sled Service Tag manually. For more information, see the Entering the sled Service Tag section.
b. Re-enable the Trusted Platform Module (TPM). For more information, see the Re-enabling the Trusted Platform Module
(TPM) section.
7. If necessary, update the BIOS and iDRAC versions.
Related links
Safety instructions
Before working inside your system
Removing a sled
Installing the SAS connector protector
Installing the SSD SATA cable into the sled
Installing the SATA cable into the sled
Installing a mezzanine card
Installing the expansion card riser assembly
Installing the processor and heat sink module
Installing the 1.8-inch solid state drive carrier
Installing the 1.8-inch solid state drive
Installing the memory modules
Installing the air shroud

SAS connector protector

The SAS connector protector is a shield that is fixed to the system board to protect the SAS connector from any damage that may
occur during shipping.

Removing the SAS connector protector

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Remove the system board from the sled
Steps
1. To release the SAS connector protector, lift the plastic securing hook from the system board.
2. To disengage the SAS connector protector from the guide slots on the system board, pull the protector away from the system
board
131