Installing The Power Distribution Boards - Dell PowerEdge C6320p Owner's Manual

Next steps
1. Install the PDBs.
2. Install the PSUs.
3. Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a power supply unit

Installing the power distribution boards

Installing a power supply unit
After working inside your system
Installing the power distribution boards
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
CAUTION: If removed, you must install the power distribution board 2 (PDB 2) and the PDB bridge board, before
installing PDB 1.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the power supply units (PSUs).
4. Keep the Phillips #2 and the Torx T20 screwdrivers ready.
Steps
1. Install PDB 2
a. Align the screw holes on PDB 2 with the holes on the chassis.
NOTE: To install PDB 2, orient the PDB2 so that the board slides into place.
b. Install the screws that secure PDB 2 to the system.
c. Secure the four power cables to PDB 2 with screws.
d. Install the power cable cover for PDB 2 and secure it with the screw.
151