Removing The 1.8-Inch Solid State Drive Carrier - Dell PowerEdge C6320p Owner's Manual

Related links
Safety instructions
Before working inside your system
Removing a sled
Installing a sled
After working inside your system

Removing the 1.8-inch solid state drive carrier

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Remove the 1.8-inch solid state drive (SSD).
5. Keep the Phillips #2 screwdriver ready.
Steps
1. Using the Phillips screwdriver, loosen the two captive screws that secure the SSD carrier to the sled.
2. Lift the SSD carrier away from the sled.
Figure 29. Removing the 1.8-inch SSD carrier
Next steps
1. Install the 1.8-inch SSD carrier.
2. Install the SSD into the carrier.
75