Table of Contents
Advertisement
Next steps
1.
Install the SSD SATA cable.
2.
Install the SATA cable.
3.
If removed, install the PCIe expansion card riser assembly.
4.
Install the air shroud.
5.
Install the sled into the enclosure.
6.
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a sled
Removing the air shroud
Removing the SATA cable from the sled
Removing the expansion card riser assembly
Installing the SSD SATA cable into the sled
Installing the expansion card riser assembly
Installing the SATA cable into the sled
Installing the air shroud
Installing a sled
After working inside your system
Installing the SSD SATA cable into the sled
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
NOTE: Observe the routing of the cables when removing them from the system. Route these cables properly when you
replace them to prevent the cables from being pinched or crimped.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Remove the sled from the enclosure.
4.
Remove the air shroud.
5.
If installed, remove the SATA cable.
NOTE: The SSD SATA cable needs to be installed first so that it lies beneath the SATA cable.
6.
If installed, remove the PCIe expansion card riser assembly.
Steps
1.
Connect the cable to the 1.8 inch SSD.
2.
Reconnect the SSD power cable to the connector on the system board.
3.
Connect the SSD SATA cable to the connector on the system board until the clips click into place.
80
Advertisement
Table of Contents
Troubleshooting
