Installing The Fabric Processor Into The Processor Heat Sink Module - Dell PowerEdge C6320p Owner's Manual

Figure 42. Removing the processor bracket
Next steps
1. Install the processer into the processor heat sink module.
2. Install the processor heat sink module into the sled.
3. Install the air shroud.
4. Install the sled into the enclosure.
5. Follow the procedure listed in the After working inside your system section.
NOTE: For more information see the video at

Installing the fabric processor into the processor heat sink module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is
necessary to maintain proper thermal conditions.
WARNING: The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat
sink to cool before removing it.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Remove the air shroud.
Steps
1. Ensure that the processor is in the CPU tray.
www.Dell.com/QRL/Server/C6320p/Processor
91