Removing The Fabric Cable From The Processor - Dell PowerEdge C6320p Owner's Manual

NOTE: The Intel Xeon Phi 72XXF processor needs a fabric cable, a side band cable, and a carrier card to be able to fully
utilise all the connectivity features.
Use the following procedure when:
• Removing and installing a heat sink
• Replacing a processor
• Removing and installing a fabric cable
Table 28. Supported processors
Processor wattage
215 W
230 W
245 W
260 W

Removing the fabric cable from the processor

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Remove the air shroud.
Steps
1. Pull the white tab on the fabric connector to release the connector from the processor base plate.
2. Slide the connector away from the processor to disengage and release it from the processor.
Processor model number
7210
7230
7250
7210F
7230F
7250F
7290
7290F
Operating temperature
10°C to 35°C (50°F to 95°F)
23°C (73.4°F)
83