Installing The Control Panel - Dell PowerEdge C6320p Owner's Manual

Figure 119. Removing the right control panel assembly
5. Push aside the retention hooks on the control panel assembly.
6. Remove the control panel from the control panel assembly.
7. Disconnect the control panel cable.
Next steps
1. Install the control panel assembly.
2. Install the hard drive cage into the enclosure. The procedure to install the hard drive cage is similar to Installing the backplane.
3. Reconnect the disconnected cables.
4. Install all the removed hard drives.
5. Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a hard drive carrier

Installing the control panel

Installing a hard drive carrier
After working inside your system
Installing the control panel
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
NOTE: Observe the routing of the cable on the chassis as you remove them from the system. You must route these
cables properly when you replace them to prevent the cables from being pinched or crimped.
NOTE: Additional tape maybe required to secure the cables.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the control panel.
171