Removing The Ssd Sata Cable From The Sled - Dell PowerEdge C6320p Owner's Manual

Related links
Safety instructions
Before working inside your system
Removing a sled
Removing the air shroud
Installing the SATA cable into the sled
Installing the air shroud
Installing a sled
After working inside your system

Removing the SSD SATA cable from the sled

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
NOTE: Observe the routing of the cable as you remove it from the system. Route the cable properly when you replace it
to prevent the cable from being pinched or crimped.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Remove the air shroud.
5. Remove the SATA cable.
6. If installed, remove the PCIe expansion card riser assembly.
Steps
1. Holding the blue pull tab, pull the solid-state drive (SSD) SATA cable away from the SATA port on the system board.
2. Disconnect the SSD SATA cable from the SSD power connector on the system board.
3. Disconnect the SSD SATA cable from the 1.8-inch SSD.
4. Lift the SSD SATA cable out of the sled.
Figure 32. Removing the SSD SATA cable
79