Removing A Power Supply Unit - Dell PowerEdge C6320p Owner's Manual

Table 31. Supported PSU configurations for non fabric processors
PSU
1400 W
1600 W
Table 32. PSU supported configurations for fabric processors
PSU
1400 W
1600 W

Removing a power supply unit

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
CAUTION: The system requires at least one working power supply unit (PSU) to operate.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Disconnect the power cable from the power source and the PSU, and disconnect the peripherals.
Sled configuration
Supports up to 215 W processor, three hard drives, and four
memory modules per system board (Sled with Mellanox
ConnectX-4 embedded controller).
Supports up to 215 W processor, four hard drives, and four
memory modules per system board (Sled without Mellanox
ConnectX-4 embedded controller).
Supports up to 215 W processor, two hard drives, and six
memory modules per system board (Sled without Mellanox
ConnectX-4 embedded controller).
Supports up to 245 W processor, two hard drives, and six
memory modules per system board (Sled with Mellanox
ConnectX-4 embedded controller).
Supports up to 245 W processor, four hard drives, and four
memory modules per system board (Sled with Mellanox
ConnectX-4 embedded controller).
Supports up to 245 W processor, six hard drives, and four
memory modules per system board (Sled without Mellanox
ConnectX-4 embedded controller).
Supports up to 245 W processor, three hard drives, and six
memory modules per system board (Sled without Mellanox
ConnectX-4 embedded controller).
Sled configuration
Supports up to 230 W processor, two hard drives, and four
memory modules per system board
Support up to 230 W processor, four hard drives, and two
memory modules per system board
Support up to 260 W processor, two hard drives, and six
memory modules per system board
Support up to 230 W processor, four hard drives, and four
memory modules per system board
139