4.
Keep the Phillips #2 screwdriver ready.
Steps
1.
Place the expansion card assembly into the system board assembly.
2.
Align the riser card connector with the connector on the system board and press the expansion card riser assembly into place.
3.
Install the screws that secure the expansion card riser assembly.
Figure 52. Installing the expansion card riser assembly
Next steps
1.
Install the sled into the enclosure.
2.
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a sled
Installing a sled
After working inside your system
Removing an expansion card
Prerequisites
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Remove the sled from the enclosure.
4.
Remove the expansion card riser assembly.
5.
Keep the Phillips #2 screwdriver ready.
102