Installing The Sas Connector Protector - Dell PowerEdge C6320p Owner's Manual

Figure 76. Removing the SAS connector protector
Next steps
1. Install the SAS connector protector.
2. Install the system board into the sled.
3. Install the sled into enclosure.
4. Follow the procedure listed in the After working inside your system section.

Installing the SAS connector protector

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Remove the system board from the sled.
Steps
1. Align and insert the SAS connector protector into the guide slots on the system board.
2. Push the protector so that the plastic securing hook locks into the slot on the system board.
132