NOTE: Ensure that the correct removal sequence is followed to avoid damaging the processor and the socket.
2.
Loosen the remaining processor and heat sink module retention screws by following the sequence on the heat sink label.
3.
Lift the processor and heat sink module away from the system board, and set the module aside with the processor side facing
up.
Figure 39. Removing the processor and heat sink module
Next steps
1.
Replace the heat sink and processor module.
NOTE: Install the processor dust cover if the processor and heat sink module is not being replaced.
2.
If removed, reconnect the fabric cable to the fabric processor.
3.
Install the air shroud.
4.
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a sled
Removing the air shroud
Installing the processor and heat sink module
Installing the air shroud
Installing a sled
After working inside your system
87