Remove, Replace, And Install The Internal Poe Daughter Card - Cisco 4000 Series Hardware Installation Manual

Chapter 5 Install and Upgrade Internal Modules and FRUs

Remove, Replace, and Install the Internal PoE Daughter Card

Read the
Step 1
module.
Remove the five screws.
Step 2
Remove the power cable to motherboard.
Step 3
Access the PoE card slot. See the
Step 4
Step 5 Locate the card to be removed or replaced. See
motherboard.
Figure 5-58
1
Step 6 Pull the PoE daughter card out of the connector on the motherboard.
If you are replacing the card, insert the new PoE daughter card into the slot. Tighten the screws, and
connect the power cable to the motherboard.
Place the removed card in an antistatic bag to protect it from ESD damage.
Step 7
OL-32185-02
"Safety Warnings" section on page 5-2
Location of the PoE Daughter Card (Shown: Cisco 4451-X ISR )
1
Location of the PoE card on the mother board.
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Remove, Replace, and Install the Internal PoE Daughter Card
and disconnect the power supply before you replace any
"Remove and Replace Chassis Cover" section on page
Figure 5-58 for the location of the PoE card on the
5-4.
5-79