Installing the SAN Switch 2/32
Optional Configuration Settings
The following sections describe how to modify domain IDs and status policies.
Modifying Domain IDs
Optional. Modify the domain IDs, if desired, as follows.
Note:
switch is connected to the fabric, the domain ID for the new switch is automatically reset
to a unique value. The domain IDs that are currently in use can be determined using the
telnet command fabricShow.
1. Disable the switch by entering the following:
2. Enter the following:
3. Enter y after the Fabric parameters prompt.
4. Enter a unique domain ID (such as the domain ID used by the previous
5. Complete the remaining prompts (or press CTRL+D to accept the remaining
6. Re-enable the switch by entering the following:
Specifying Custom Status Policies
Optional If desired, specify any custom status policies for the fabric as follows.
1. Enter the following at the prompt.
2. Specify the desired status policies. To completely deactivate the alarm for a
54
The default domain ID is 1. If the default domain ID is already in use when the
switchDisable
configure
Fabric parameters (y, n)
switch, if still available).
Domain: (1..239) [1] 3
settings without completing all the prompts).
switchEnable
switchStatusPolicySet
particular condition, enter 0 at the prompt for that condition.
SAN Switch 2/32 Installation Guide