Installing Mounting Brackets And Cable Management Brackets - HP 7500 Series Installation Manual

Figure 9 Installing cage nuts (7503 as an example)
(1) Cage nut

Installing mounting brackets and cable management brackets

Before installing the switch to the rack, install the mounting brackets and cable management brackets
shipped with the switch. Cable management brackets (signal cable and power cable management
brackets) are used for cabling the switch, and mounting brackets are used for attaching the chassis to the
rack.
7506-V—Install the mounting brackets and cable management brackets separately to the chassis.
•
For more information, see
"Installing mounting
• Other models—Install the cable management brackets to the mounting brackets, and then install
the mounting brackets to the chassis. For more information, see
brackets on other
Installing the cable management brackets on the 7506-V
The 7506-V has two cable management brackets—the one with a tray is installed at the lower part of the
switch, and the one without a tray is installed at the upper part of the switch. They are installed in the
same way.
"Installing the cable management brackets on the
brackets."
models" and "Installing mounting
13
"Attaching the cable management
brackets."
7506-V" and