Displaying Switch Configuration Settings; San Switch 2/32 Diagnostics; Interpreting Post Results - HP StorageWorks 2/32 - SAN Switch Installation Manual

Note:
than 70 are interpreted as 2000
saving time or time zones.

Displaying Switch Configuration Settings

Follow these steps to display the system configuration settings.
1. Log in to the switch as the admin user.
2. Issue the configShow command.

SAN Switch 2/32 Diagnostics

This section provides information on using POST and diagnostic tests.

Interpreting POST Results

Each time the switch is powered on or reset, the switch automatically performs
POST, a one-minute system check during which the port status LEDs flash
different colors.
To determine whether POST completed without errors, verify that all LEDs return
to a normal state after POST is complete. If one or more LEDs do not return to a
normal state, and this is not due to the switch being set to beacon, refer to the HP
StorageWorks Fabric OS 4.2.x Procedures User Guide.
Note:
successfully complete. The switch should be returned to your switch supplier for repair.
Any errors detected during POST are written to the system log, accessible through
the errShow command. For more information about error messages, refer to the
HP StorageWorks Fabric OS 4.2.x Procedures User Guide.
SAN Switch 2/32 Version 4.2.x Installation Guide
— hh is the hour; valid values are 00–23.
— mm is minutes; valid values are 00–59.
— YY is the year; valid values are 00–99.
Year values greater than 69 are interpreted as 1970
The system configuration settings display.
If the switch prompt does not display when POST completes, POST did not
2069. The date function does not support daylight
–
Managing the SAN Switch 2/32
1999; year values less
–
63