Muting and Unmuting Outputs from the Front Panel
NOTES:
DXP 88 Series — Muting and Unmuting Outputs
1.
2.
3.
To unmute an output, press and hold the blinking output button until the blinking stops
(approximately 2 seconds).
NOTE: In the DXP 44, 84, and 88, if you want to mute an output, but accidentally press
•
You can mute video and audio, video-only, or audio-only outputs. Pressing and
releasing the
button and the
Video
•
When the DXP enters view-only mode, the output LEDs light for all outputs
without ties.
•
Mutes are saved to non-volatile memory. When power is removed and
restored, the mute settings are retained.
•
Mutes are protected when front panel lock mode 2 is selected. You can view the status
of the output (muted or unmuted) in lock mode 2 but you cannot change it from the
Locking and Unlocking the Front Panel (Executive Modes)
front panel (see
page 45).
•
To enable changes to the mute settings, set the lock mode to 0.
Press
to clear any leftover button selections or incomplete ties.
Esc
Press the
button to toggle to your desired selection, Video (green LED lights) or
I/O
Audio (red LED lights).
I/O
Press I/O button to
select audio or video.
I/O
AUDIO
Figure 64.
Selecting Audio or Video to Mute
Press the button for the output to be muted, and hold it until its LED begins to blink
(approximately 2 seconds). The LED continues to blink until the output is unmuted.
Press and hold the desired
Output button.
1
2 seconds
NOTE: Video is muted in this example.
Figure 65.
Muting an Output
an input button prior to pressing and holding the desired output, this voids the output
muting process and activates the tie process.
button toggles each selection on and off.
Audio
VIDEO
Lights green when video is selected.
Lights red when audio is selected.
1
Green = Video is muted.
Red = Audio is muted.
DXP HD 4K Series • Operation
on
The button blinks to indicate
that the output is muted.
41