Extron electronics DXP 44 HD 4K User Manual page 32

2. Press and release the
I/O
NOTE: For the DXP 88 Series, you cannot select both audio and video for a tie at
the same time. You must repeat the tie process for each type of tie (audio and
video) that you want to create for the desired input and output.
For example, first create a video tie between an input and output, then create an
audio tie for the same input and output.
I/O
Press I/O button to
select audio or video.
I/O
Figure 17. Selecting Audio or Video using the I/O Button
3. Press the desired input button.
The LED lights to
indicate the selection.
1
Figure 18. Selecting an Input for the Tie
4. Press the output buttons to which the input will be tied. Each selected output LED
blinks green for a video tie or red for an audio tie. The Enter LED also blinks to indicate
that a tie has been initiated.
Press one or more Output buttons.
• Green blinking LED indicates a video-only tie.
• Red blinking LED indicates an audio-only tie
(de-embedded audio outputs 1 and 2).
1
or
ENTER
Blinking green LED indicates
the need to confirm the change.
Figure 19. Selecting an Output for the Tie
5.
Press the button. All button LEDs turn off.
Enter
DXP 1616 series
In the following example, input 4 is being tied to outputs 1, 2, and 3.
NOTE: This example assumes that there are no ties in the current configuration.
1. Press and release the
Esc
Press the Esc button to clear all selections.
C O N T R O L
VIEW ESC
ENTER PRESET
The button blinks once.
Figure 20. Clear all Selections
button to select video or audio as desired.
VIDEO
Lights green when video is selected.
Lights red when audio is selected.
AUDIO
1
>
button.
DXP HD 4K Series • Operation 24