Table of Contents
Advertisement
im Vertrieb von
Operation, cont'd
7.
Figure 3-32 — Press the View button to exit View-Only mode
Muting and unmuting video and/or audio outputs
Individual video and outputs can be muted or unmuted as follows:
1.
2.
3.
4.
5.
N •
www.camboard.de
MPX 866 A Media Presentation Matrix Switcher • Operation
3-20
CAMBOARD Electronics
Press and release the View button to exit View-Only mode (fi gure 3-32).
Press the View button
to exit View-Only mode.
CONTROL
The View LED returns
to the unlit state.
All input LEDs and output
LEDs return to the unlit state.
PRESET
VIEW
Press the Esc button to clear any input LEDs, output LEDs, or control LEDs
that may be lit.
Press and release the View button.
Select video or audio to mute or unmute by pressing the Video button and/or
the Audio button.
One at a time, press and hold the output button(s) for the desired output(s)
for approximately 2 seconds. The output LED(s) for the selected output(s)
blink to indicate the mute or return to their previous state to indicate the
unmute.
Press and release the View button to return to normal switcher operation.
You can mute video-only or audio-only outputs only in a single operation.
•
Video and audio can both can be muted, but in separate operations; one and
then the other.
•
Pressing and releasing the Video button and the Audio button toggles each
selection on and off.
•
If you select Video and Audio in View-Only mode and then attempt to mute
an output, the mute function will not work.
•
When you enter View-Only mode, the output LEDs turn on for all outputs
without ties.
•
In the computer video group, the video mute function mutes the R, G, and B
planes only; the sync (H and V planes) are still active.
•
In the low resolution video group, the video mute function mutes all
composite video and/or S-video planes.
•
Mutes are saved to non-volatile memory. When power is removed and
restored, the mute settings are retained.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de
Advertisement
Table of Contents
