Mode
Activation
1
Hold in the recessed
while applying power to the switcher.
4
Hold in the
Reset
Reset LED blinks twice (once after
approximately 3 seconds and
again after 6 seconds). Then, within
1 second press
Reset
less than 1 second).
5
Hold in the
Reset
Reset LED blinks three times (once
after approximately 3 seconds, again
after 6 seconds, and then again after
9 seconds); then within 1 second
press Reset momentarily (for less than
1 second).
Reset Modes Summary for DXP HD 4K Series
Result
button
•
Restores the factory-installed
Reset
firmware for a single power cycle.
•
Event scripts do not start.
Maintains all user files and settings
•
(drivers, audio adjustments, IP
settings, and so on) are maintained.
•
It does not clear the current
configuration.
button until the
•
Sets the IP address, subnet address,
and gateway address to the factory
defaults.
Sets port mapping to the factory
•
momentarily (for
default.
•
Turns DHCP off.
Turn event scripts off.
•
The Reset LED blinks four times in quick
succession during the reset.
button until the
Performs a complete reset to factory
defaults (with the exception of the
firmware), which includes:
•
Everything mode 4 does
Reset of all real time adjustments:
•
•
•
•
The reset LED blinks four times in quick
succession during the reset.
Clears all ties, presets, and audio or
RS-232 mutes.
Resets all IP options.
Removes or clears all switcher files.
DXP HD 4K Series • Operation
Purpose/Notes
Use mode 1
to revert to the
factory firmware
if incompatibility
issues arise.
Mode 4 resets
all IP settings to
factory defaults.
It does not replace
any user-installed
firmware.
Mode 5 is useful
if you want to
start over with
configuration and
uploading and also
to replace events.
Equivalent to
SIS command
E
} .
ZQQQ
50