Extron electronics DXP 44 HD 4K User Manual page 16

Input connectors — Connect HDMI source devices to these female 19-pin type A
A
HDMI input connectors.
LockIt cable lacing brackets, one for each HDMI input and output connector, are
provided with the DXP HD 4K. These brackets can be used to secure the HDMI cables
to the DXP connectors to reduce stress on the HDMI connectors and prevent signal
loss due to loose cable connections.
For information on attaching the LockIt brackets, see the LockIt HDMI Lacing Bracket
Installation Guide card, available on the Extron website at www.extron.com.
Output connectors — Connect HDMI output devices to these female 19-pin type A
B
HDMI output connectors for buffered video output. See the provided LockIt instruction
card to securely fasten an HDMI cable to the DXP using LockIt brackets.
Reset LED — This green LED remains lit while the DXP has power. While the
C
button ( ) is being pressed and held, this LED blinks every 3 seconds to indicate the
D
level of reset that will be initiated if the button is released at that point (see
page 47 for more information).
Reset button — This recessed button initiates four levels (modes) of reset on the DXP
D
switcher. To initiate the different reset levels, use a pointed object such as a small Philips
screwdriver or a stylus to press and hold the button while the switcher is running or
while it is being powered up (see Resetting).
Remote connector — Connect a host device, such as a computer or touch panel
E
control, to the switcher via this 3-pole 3.5 mm captive screw connector for serial
RS-232 control (see Connecting to the Remote RS-232 Port
Connect the 9-pin connector end of the RS-232 cable to the serial port of your
computer or control system.
LAN port — Connect the DXP switcher to a computer, a network switch, or
F
a control system via this RJ-45 connector. You can use a computer to
configure and control the networked switcher with SIS commands, the PCS
configuration software, or the HTML page that is embedded on the switcher
(see Connecting to the LAN port
Ethernet connection indicators — The Link and Act LEDs within the LAN
connector indicate the status of the Ethernet connection. The green Link LED
indicates that the switcher is properly connected to an Ethernet LAN. This
LED should light steadily. The amber Act (Activity) LED indicates transmission
of data packets on the RJ-45 connector. This LED should flicker as the switcher
communicates.
on page 10).
DXP HD 4K Series • Installation
Reset
Resetting on
on page 11.
DXP 1616
Series
LAN
DXP 88 Series
8