Connecting To The Usb Config Port - Extron electronics DXP 44 HD 4K User Manual

Connecting to the USB Config Port

The USB mini-B Config port is located on the DXP front panel. It provides an alternative
connection for configuring the switcher via SIS commands.
1.
DXP 4K HD
Extron
CONFIG
2.
Use a USB A to mini-B cable to connect the USB Config port to a USB port on the
computer.
NOTE: Figure 9 shows a DXP 88 4K HD series. The front panels of the DXP 1616
and 168 have the Config port near the center, between the block of input and
output buttons and the control buttons.
USB Mini-B
USB Cable
INPUTS
1 2 3 4 1
5 6 7 8 5
Figure 9. Connecting to the Front Panel USB Config Port
If this is the first time you have connected a DXP HD 4K to this particular USB port on
your computer, you may need to download the USB driver for DXP.
USB A
USB
Ports
OUTPUTS
2 3 4
ENTER PRESET ESC I/O
6 7 8
DXP HD 4K Series • Installation
Computer
USB 1
DXP HD 4K SERIES
INPUTS
DIGITAL CROSSPOINT MATRIX SWITCHER
VIDEO
SIGNAL
1 2 3 4 5 6 7 8
HDCP
AUDIO
12