To perform a hardware reset of the switcher:
1.
2.
Selecting the Remote RS-232 Port Baud Rate
NOTES:
To view and configure the serial communications settings for the switcher from the front
panel:
1.
Use a stylus or small Philips screwdriver to press and hold the rear panel
until the front panel
and
Video
times (for an absolute reset).
Press and hold
the Reset button.
Reset LED blinks twice.
6 seconds
IP Settings
Reset
(Mode 4)
Front panel I/O buttons or LEDs blink twice.
I/O
DXP 88 Series
Press and hold
the Reset button.
9 seconds
Absolute Reset
(Mode 5)
Front panel I/O buttons blink three times.
I/O
DXP 88 Series
Figure 77.
Soft Resets (Modes 4 and 5)
Release the
button and then immediately press and release it again. Nothing
Reset
happens if the second momentary press does not occur within 1 second.
•
The serial port settings are protected when front panel lock mode 2 is selected. You
can view the settings in lock mode 2 but you cannot change them from the front
panel.
•
To enable changes to the baud rate settings, set the lock mode to
Simultaneously press and hold all Control buttons (
and 1616 only] and
) until all of the Control buttons or their LEDs light, as well as
Esc
input buttons 1 and 2 (approximately 2 seconds).
buttons blink twice (for a system reset) or three
Audio
Release, then immediately
press and release again.
VIDEO
I / O
VIDEO
AUDIO
AUDIO
DXP 1616 Series
Reset LED blinks
Release, then immediately
three times.
press and release again.
VIDEO
I / O
VIDEO
AUDIO
AUDIO
DXP 1616 Series
Enter
DXP HD 4K Series • Operation
button
Reset
.
0
,
,
[DXP 168
Preset
View
51