[Cj] Function Of Individual Operation Of The Machine Head; [Ck] Setting Of The Number Of Revolutions Of The Machine Head Motor; [Cl] Setting Of The Machine Head Motor Operating Time; [Cm] Setting Of The Machine Head Motor Stop Time - JUKI MOL-254 Engineer's Manual

(10) [CJ] Function of individual operation of the machine head

Driving of the machine drive motor only is performed.
The respective modes, M-0, M-1 and M-2 can be selected.
M-0 : Individual operation of machine head is prohibited. (Normal operation is prior.)
M-1 : Machine head drive motor runs at the specified speed.
M-2 : Machine head drive motor runs at the specified speed and stop of setting time
is repeated.
Start button for starting operation is the starting switch of the upper DIP SW No. 8
located on the right side of the operation box panel for safety.

(11) [CK] Setting of the number of revolutions of the machine head motor

Number of revolutions of the machine head motor when operating [CJ] is set.
K
This is the number of revolutions at the time of start, and the number of revolutions
can be changed through the operation box panel when the machine head starts up.
This is not displayed unless M-1 or M2 of [CJ] setting is set.

(12) [CL] Setting of the machine head motor operating time

Operating time of the machine head when operating [CJ] is set. This setting performs
operation and stop based on the number of revolutions set in [CK] and stop time of
set value in [CM].
Operation or stop is performed based on [CM] set value.
This is not displayed unless M-2 of [CJ] setting is set.
(Caution) The machine head operates within the setting time regardless of the

(13) [CM] Setting of the machine head motor stop time

Stop time of the machine head when operating [CJ] is set. This setting performs
operation and stop based on the number of revolutions set in [CK] and operating time
of set value in [CL].
This is not displayed unless M-2 of [CJ] setting is set.
(Caution) The machine head operates within the setting time regardless of the

(14) [CN] Setting of the position compensation of the machine head and the supply device

Compensation of the position of the machine head and the supply device is performed.
Positioning using the positioning jig or the like is performed in the production line.
However, the final fine adjustment is electrically performed.
number of stitches.
number of stitches.
155
− −