JUKI MOL-254 Engineer's Manual page 89

Adjustment Procedures
1. Remove the chip cover.
2. Draw out the rod in knife turn cylinder
knife base to adjust so that loop cut knife
right angle against belt loop
3. Fit clamp collar to the bushing on the rod side of cylinder,
and fix it with setscrew
and turn counter
is almost at
.
.
82
− −
Results of Improper Adjustment
○ A f t e r t h e c o m p l e t i o n o f
adjustment, perform a trial of
sewing and confirm that loop
supplying has been performed
as adjusted.
○ If there is any trouble upon the
confirmation, adjust again with
the same adjustment procedure.