Loop Pull-Out Cylinder (Optional); Fullness Cylinder (Optional); Needle Cooler (Optional) - JUKI MOL-254 Engineer's Manual

4) Loop pull-out cylinder (Optional)

1. Adjustment amount of the speed controller on the rod side : Give the adjustment screw 7 turns
after fully opened.
2. Adjustment amount of the speed controller on the anti-rod side : Give the adjustment screw 4.5
turns after fully opened.

5) Fullness cylinder (Optional)

1. Adjustment amount of the speed controller on the anti-rod side : Give the adjustment screw six
turns after fully opened.

6) Needle cooler (Optional)

1. Adjustment amount of the speed controller : Give the adjustment screw two turns after fully opened.
Standard Adjustment
6 turns
6 turns
121
− −
4.5 turns
7 turns