Adjusting The Height Of The Fork (Up/Down Of This Side And Far Side) - JUKI MOL-254 Engineer's Manual

4) Adjusting the height of the fork (up/down of this side and far side)

1. Clearances provided between the top surface sides of the forks in the right and left rotation centers
and the bottom surfaces of the belt loops should be equal respectively at the positions where the
forks clamp the belt loops from the loop receivers.
2. At this time, check that a clearance is provided between the top surface of front fork end of the
folding shaft metal and the folding shaft.
Standard clearance is 1 mm.
Standard Adjustment
Folding shaft wires in
rotation center
113
− −